Agilent Technologies Signal Analyzer N9030a - Manual (Page 595)

6 RLC Swept SA Measurement Front-Panel & SCPI Reference
Input/Output
The [:SENSe]:FEED RF|IQ|IONLy|QONLy|AREFerence|IFALign command supports all parameters
except IFALign. The FEED? query returns only RF|AIQ|AREF.
The following commands are not supported:
l
:CALibration:GIQ
l
:CALibration:IQ:CMR
l
:INPut:IQ:ALIGn OFF|ON|0|1
The Rohde & Schwarz FSQ-B71 also provides baseband I/Q inputs. A certain amount of code
compatibility is provided in the X-Series, however hardware differences make this a somewhat
limited set.
Supported:
l
The "<1|2>" is supported as "[1]".
l
INPut<1|2>:IQ:BALanced[:STATe] ON | OFF
l
INPut<1|2>:IQ:TYPE I | Q | IQ
l
INPut<1|2>:IQ:IMPedance LOW | HIGH
Not Supported:
l
INPut<1|2>:SELect AIQ | RF
l
TRACe<1|2>:IQ:DATA:FORMat COMPatible | IQBLock | IQPair>
l
TRACe<1|2>:IQ:DATA:MEMory? <offset samples>,<# of samples>
l
TRACe<1|2>:IQ:DATA?
l
TRACe<1|2>:IQ:SET <filter type>,<rbw>,<sample rate>,<trigger source>,<trigger slope>,
<pretrigger samples>, <# of samples>
l
TRACe<1|2>:IQ:SRATe 10.0kHz to 81.6MHz
l
TRACe<1|2>:IQ[:STATe] ON|OFF
The Rohde & Schwarz FMU has the following SCPI, which is not supported (these commands
start/abort the probe calibration procedure, which is manually interactive from the front panel):
l
CALibration:ABORt
l
CALibration:PROBe[:STARt]
Remote Language Compatibility Measurement Application Reference 595