Agilent Technologies Signal Analyzer N9030a - Manual (Page 627)

6 RLC Swept SA Measurement Front-Panel & SCPI Reference
Input/Output
Select Correction
Specifies the selected correction. The term "selected correction" is used throughout this document
to specify which correction will be affected by the functions.
Key Path Input/Output, Corrections
Mode SA
Notes The selected correction is remembered even when not in the correction menu.
Preset Set to Correction 1 by Restore Input/Output Defaults
Readback Correction 1|Correction 2|Correction 3|Correction 4|Correction 5|Correction 6
Initial S/W Revision A.02.00
Select Correction
Specifies the selected correction. The term "selected correction" is used throughout this document
to specify which correction will be affected by the functions.
Key Path Input/Output, Corrections
Mode SA
Notes The selected correction is remembered even when not in the correction menu.
Preset Set to Correction 1 by Restore Input/Output Defaults
Readback Correction 1|Correction 2|Correction 3|Correction 4|Correction 5|Correction 6
Initial S/W Revision A.02.00
Correction On/Off
Turning the Selected Correction on allows the values in it to be applied to the data. This also
automatically turns on "Apply Corrections" (sets it to ON), otherwise the correction would not take
effect.
A new sweep is initiated if an amplitude correction is switched on or off. Note that changing,
sending or loading corrections data does NOT directly initiate a sweep, however in general these
operations will turn corrections on, which DOES initiate a sweep.
Key Path Input/Output, Corrections
Remote Command [:SENSe]:CORRection:CSET[1]|2|...6[:STATe] ON|OFF|1|0
[:SENSe]:CORRection:CSET[1]|2|...6[:STATe]?
Remote Language Compatibility Measurement Application Reference 627