Agilent Technologies Signal Analyzer N9030a - Manual (Page 1230)

6 RLC Swept SA Measurement Front-Panel & SCPI Reference
Sweep/Control
Maximum line is 313 for formats PAL-B, D, G, H, I, PAL-N, PAL-N Combin, and SECAM-L.
Readback Field 1
Initial S/W Revision Prior to A.02.00
Field Two
When you select Field Two it causes the selected line number to be viewed as an offset into the
second field. If Line 1 is selected, it is the 264th line of the frame (NTSC-M, NTSC-Japan, NTSC–
4.43, PAL-M, PAL–60) or the 314th line of the frame (PAL-B,D,G,H,I, PAL-N, PAL-N-Combin,
SECAM-L).
Key Path Trigger, TV, Field
Example TRIG:TV:FMOD EVEN
Min Field 2 (EVEN)
The minimum line is 1
Max Field 2 (EVEN)
The maximum line 262 for formats NTSC-M, NTSC-Japan, NTSC–4.43, PAL-M and PAL–60
The maximum line is 312 for formats PAL-B, D, G, H, I, PAL-N, PAL-N Combin, and SECAM-L
Readback Field 2
Initial S/W Revision Prior to A.02.00
Standard
Accesses the Standard menu keys which select from the following TV standards: NTSC-M, NTSC-
Japan, NTSC–4.43, PAL-M, PAL-B,D,G,H,I , PAL-N, PAL-N-Combin, PAL–60, SECAM-L.
As the TV standard is changed, the current line value is clipped as necessary to keep it valid for
the chosen standard and field mode. For example, line 600 is selected in Entire Frame mode in
PAL-N; if NTSC-M is selected, the line number is clipped to 525. Or, if line 313 is selected in Field
1 mode in PAL-N and NTSC-M is selected, the line number is clipped to 263. Changing back to the
PAL-N standard will leave the line number at 263.
Key Path Trigger, TV
Remote Command :TRIGger[:SEQuence]:TV:STANdard MNTSc | JNTSc | NTSC443 | MPAL | BPAL |
NPAL | CPAL | PAL60 | LSEC
:TRIGger[:SEQuence]:TV:STANdard?
Example TRIG:TV:STAN MPAL
TRIG:TV:STAN?
1230 Remote Language Compatibility Measurement Application Reference