Agilent Technologies Signal Analyzer N9030a - Manual (Page 843)

6 RLC Swept SA Measurement Front-Panel & SCPI Reference
Meas Setup
the range to either the high or low gain setting. But you must know that your measurement
conditions will not overload the IF (in the high gain range) and that your signals are well above
the noise floor (for the low gain range), and that the signals are not changing.
Key Path Meas Setup
Remote Command [:SENSe]:IF:GAIN:FFT[:STATe] AUTOrange|LOW|HIGH
[:SENSe]:IF:GAIN:FFT[:STATe]?
Couplings As with most parameters with an AUTO state, AUTO COUPLE sets it to Auto, which then picks
AUTOrange, and setting any specific value (AUTOrange, LOW or HIGH) will set the AUTO state
to false.
Preset AUTOrange
State Saved Saved in instrument state.
Readback Line Autorange, High Gain or Low Gain
Initial S/W Revision Prior to A.02.00
Auto
Allows the instrument to pick the FFT IF Gain method as appropriate. This “Auto” state is set by
the Auto Couple key, and it puts it in Autorange.
Key Path Meas Setup
Remote Command [:SENSe]:IF:GAIN:FFT:AUTO[:STATe] OFF|ON|0|1
[:SENSe]:IF:GAIN:FFT:AUTO[:STATe]?
Example IF:GAIN:FFT:AUTO ON
Preset ON
State Saved Saved in instrument state.
Backwards
Compatibility SCPI DISPlay:WINDow[1]:TRACe:Y[:SCALe]:LOG:RANGe:AUTO
Included for ESA compatibility
Backwards
Compatibility SCPI [:SENSe]:ADC:RANGe AUTO|NONE
Included for PSA compatibility. Accepted without error but ignored; the query is ignored as well
Initial S/W Revision Prior to A.02.00
Remote Language Compatibility Measurement Application Reference 843