Agilent Technologies Signal Analyzer N9030a - Manual (Page 1294)

6 RLC Swept SA Measurement Front-Panel & SCPI Reference
System
I/O Config
Activates a menu for identifying and changing the I/O configuration for remote control.
Key Path System
Initial S/W Revision Prior to A.02.00
GPIB
Activates a menu for configuring the GPIB I/O port.
Key Path System, I/O Config
Initial S/W Revision A.02.00
GPIB Address
Select the GPIB remote address.
Key Path System, I/O Config, GPIB
Mode All
Remote Command :SYSTem:COMMunicate:GPIB[1][:SELF]:ADDRess <integer>
:SYSTem:COMMunicate:GPIB[1][:SELF]:ADDRess?
Example :SYST:COMM:GPIB:ADDR 17
Notes Changing the Address on the GPIB port requires all further communication to use the new
address.
Preset This is unaffected by Preset but is set to 18 on a “Restore System Defaults->Misc”
State Saved No
Range 0 to 30
Min 0
Max 30
Initial S/W Revision Prior to A.02.00
GPIB Controller
Sets the GPIB port into controller or device mode. In the normal state, GPIB controller is disabled,
which allows the analyzer to be controlled by a remote computer. When GPIB Controller is
1294 Remote Language Compatibility Measurement Application Reference