Agilent Technologies Signal Analyzer N9030a - Manual (Page 1429)

6 RLC Swept SA Measurement Front-Panel & SCPI Reference
Trigger
GSM: –25 dB
State Saved Saved in instrument state
Min –45 dB
Max 0 dB
Default Unit dB or dBc
Backwards
Compatibility SCPI :TRIGger[:SEQuence]:RFBurst:LEVel
This legacy command is aliased to :TRIGger[:SEQuence]:RFBurst:LEVel:RELative because the
PSA had ONLY relative burst triggering
Initial S/W Revision Prior to A.02.00
Modified at S/W
Revision A.04.00
Trigger Slope
It is set positive to trigger on a rising edge and negative to trigger on a falling edge.
Key Path Trigger, RF Burst
Remote Command :TRIGger[:SEQuence]:RFBurst:SLOPe POSitive|NEGative
:TRIGger[:SEQuence]:RFBurst:SLOPe?
Example TRIG:RFB:SLOP NEG
Couplings This same slope is used in the RF Burst selection for the trigger source in the Trigger menu and
for the period timer sync source (in the Trigger menu and in the Gate Source menu).
Preset POSitive
State Saved Saved in instrument state
Backwards
Compatibility SCPI :TRIGger[:SEQuence]:FRAMe:RFBurst:SLOPe
Backwards Compatibility
Notes The legacy :TRIGger[:SEQuence]:SLOPe command affects the slopes for the VID, LINE, EXT1,
EXT2, and RFB triggers.
Initial S/W Revision Prior to A.02.00
Trig Delay
This setting delays the measurement timing relative to the Periodic Timer.
Remote Language Compatibility Measurement Application Reference 1429