Agilent Technologies Signal Analyzer N9030a - Manual (Page 182)

4 List of Legacy Analyzer Commands
Alphanumeric List of all Legacy Commands with N9061A Support
Command Description 8566 8568
8560
Series Description
DA Display Memory Address Yes Yes N/A "DA (Display Address)" on page 271
DATEMODE Set the date display format N/A N/A No
DD Display write binary No No N/A
DELMKBW Occupied power bandwidth
within delta marker N/A N/A Yes "DELMKBW (Occupied Power Bandwidth
Within Delta Marker)" on page 272
DEMOD Turns the demodulator on
or off N/A N/A No
DEMODAGC Demodulation automatic
gain control N/A N/A No
DEMODT Demodulation time N/A N/A No
DET Detection Mode Yes Yes Yes "DET (Detection Mode)" on page 273
DISPOSE Frees Memory No No No
DIV Divide No No No
DL Display Line Level Yes Yes Yes "DL (Display Line)" on page 274
DLE Turns the display line
on/off Yes Yes N/A "DLE (Display Line Enable)" on page 276
DLYSWP Delay sweep N/A N/A Yes "DLYSWP (Delay Sweep)" on page 277
DN Reduces the active
function by applicable step
size N/A N/A N/A
DONE Synchronizing function Yes Yes Yes "DONE (Done)" on page 278
DOTDENS Sets the dot density value
in Analog+ display mode N/A N/A N/A
DR Display Memory Address
Read Yes Yes N/A "DR (Display Read)" on page 279
DRAWBOX Draws a rectangular box on
analyzer display N/A N/A N/A
DSPLY Display No No No
DT Define Terminator No No N/A
DW Display Memory Address
Write No No N/A
E1 Active marker to maximum
signal Yes Yes Yes "E1[one] (Peak Marker)" on page 280
E2 Active marker to center Yes Yes Yes "E2 [two] (Marker to Center Frequency)" on
182 Remote Language Compatibility Measurement Application Reference