Agilent Technologies Signal Analyzer N9030a - Manual (Page 600)

6 RLC Swept SA Measurement Front-Panel & SCPI Reference
Input/Output
I Skew
Sets the skew factor for the I channel. The skew will shift the channel's data in time. Use this to
compensate for differences in the electrical lengths of the input paths due to cabling.
Key Path Input/Output, I/Q, I Setup
Remote Command [:SENSe]:CORRection:IQ[:I]:SKEW <seconds>
[:SENSe]:CORRection:IQ[:I]:SKEW?
Example Delay the data for the I channel by 10 ns.
CORR:IQ:SKEW 10 ns
Preset 0
State Saved Yes
This is unaffected by Preset but is set to the default value on a "Restore Input/Output Defaults"
or "Restore System Defaults->All"
Range 0 s to 100 ns
Min 0 s
Max +100 ns
Initial S/W Revision Prior to A.02.00
I Probe
Access the probe setup parameters for the I channel. See "I/Q Probe Setup" on page 611 .
Key Path Input/Output, I/Q, I Setup
State Saved No
Readback Text [<I port probe id>]
This is reporting the type of probe sensed on the I port. There is no parameter for overriding what
is sensed.
Initial S/W Revision Prior to A.02.00
Attenuation
The attenuation is part of the calibration data stored with the probe type and is initially the
value that was returned by the last calibration. You can modify this value and any changes will
be stored with the calibration data and will survive power cycles and presets. When a probe
calibration is performed the attenuation value will be overwritten by the calibration.
Key Path Input/Output, I/Q, I Setup | Q Setup, I Probe | Q Probe
600 Remote Language Compatibility Measurement Application Reference