Agilent Technologies Signal Analyzer N9030a - Manual (Page 1448)

6 RLC Swept SA Measurement Front-Panel & SCPI Reference
View/Display
Example DISP:ANN:TITL:DATA "This Is My Title"
This example is for the Swept SA measurement in the Spectrum Analyzer mode. The SANalyzer
<measurement> name is not used.
DISP:ACP:ANN:TITL:DATA "This Is My Title"
This example is for Measurements other than Swept SA.
Both set the title to: This Is My Title
Notes Pressing this key cancels any active function.
When a title is edited the previous title remains intact (it is not cleared) and the cursor goes at
the end so that characters can be added or BKSP can be used to go back over previous
characters.
Preset No title (measurement name instead)
State Saved Saved in instrument state.
Initial S/W Revision Prior to A.02.00
Clear Title
Clears a title from the front-panel display. Once cleared, the title cannot be retrieved. After the
title is cleared, the current Measurement Name replaces it in the title bar.
Key Path View/Display, Display, Title
Example The following commands clear the title and restore the measurement’s original title:
DISP:ANN:TITL:DATA ""
This example is for the Swept SA measurement in the Spectrum Analyzer mode. The SANalyzer
<measurement> name is not used.
DISP:ACP:ANN:TITL:DATA ""
This example is for ACP; in measurements other than Swept SA the measurement name is
required.
Notes Uses the :DISPlay:<measurement>:ANNotation:TITLe:DATA <string> command with an empty
string (in the Swept SA, the <measurement> is omitted).
Preset Performed on Preset.
Initial S/W Revision Prior to A.02.00
Graticule
Pressing Graticule turns the display graticule On or Off. It also turns the graticule y-axis
annotation on and off.
1448 Remote Language Compatibility Measurement Application Reference