Agilent Technologies Signal Analyzer N9030a - Manual (Page 149)

3 Programming the Analyzer
STATus Subsystem
Preset 32767
Min 0
Max 32767
Status Bits/OPC dependencies Sequential command
Initial S/W Revision Prior to A.02.00
Questionable Calibration Skipped Register
The following commands and queries are available for this register:
"Questionable Calibration Skipped Condition" on page 149
"Questionable Calibration Skipped Enable" on page 149
"Questionable Calibration Skipped Event Query" on page 150
"Questionable Calibration Skipped Negative Transition" on page 150
"Questionable Calibration Skipped Positive Transition" on page 151
Questionable Calibration Skipped Condition
This query returns the decimal value of the sum of the bits in the Questionable Calibration
Skipped Condition register.
The data in this register is continuously updated and reflects the current conditions.
Mode All
Remote Command :STATus:QUEStionable:CALibration:SKIPped:CONDition?
Example STAT:QUES:CAL:SKIP:COND?
Preset 0
Status Bits/OPC dependencies Sequential command
Initial S/W Revision Prior to A.02.00
Questionable Calibration Skipped Enable
This command determines which bits in the Questionable Calibration Skipped Condition Register
will set bits in the Questionable Calibration Skipped Event register, which also sets bit 11 of the
Questionable Calibration Register. The variable <integer> is the sum of the decimal values of the
bits you want to enable.
Remote Language Compatibility Measurement Application Reference 149