Lenze i700 - Manual (Page 157)

Lenze · i700 servo inverter · Reference manual · DMS 1.5 EN · 03/2014 · TD05
157
6 Holding brake control
6.1 Operating modes
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
6 Holding brake control
This device function is used to control a motor holding brake connected to the i700 servo inverter.
Objects described in this chapter
6.1 Operating modes
For holding brake control, the following three operating modes available for the i700 servo inverter
in the object 0x2820:1 (or 0x3020:1 for axis B):
• Triggering via control word via external control (Lenze setting)
• Triggering via state machine of device
• No brake connected

Tip!
We recommend the use of the preset "Triggering via control word from external control"
mode. In this operating mode, the triggering is carried out via the application program in
the Controller.
You can find detailed information on the respective operating mode in the following subchapters.

Note!
In the " Fault " device status, the holding brake is applied.
Object Name Data type
Axis A Axis B
0x2820 0x3020 Brake control: Settings RECORD