Lenze i700 - Manual (Page 288)

10 Service/internal
10.1 Firmware update
288
Lenze · i700 servo inverter · Reference manual · DMS 1.5 EN · 03/2014 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
0x2DDF | 0x35DF - Axis: Device data
10.1 Firmware update
The drive component firmware can be replaced by means of the available EtherCAT interface (RJ45
socket) via FoE. In order to carry out a firmware download, the drive component must be in the
"Bootstrap" EtherCAT status. Only one firmware with the name "i700.bin" is accepted.
Sub. Name Lenze setting Data type
 1 Axis: Rated current UNSIGNED_16
 2 Axis: Maximum current UNSIGNED_16
 5 Axis: Supported feedback type 0: Product-defined UNSIGNED_8
Subindex 1: axis: rated current
Display area (min. value | unit | max. value) Initialisation
0.00 A 655.35
 Write access  CINH  OSC  P  RX  TX Scaling: 1/100 UNSIGNED_16
Subindex 2: axis: maximum current
Display area (min. value | unit | max. value) Initialisation
0.00 A 655.35
 Write access  CINH  OSC  P  RX  TX Scaling: 1/100 UNSIGNED_16
Subindex 5: Axis: Supported feedback type
From version 01.03
Selection list (read only)
0 Product-defined
1 No feedback system
2 Resolver
3 SinCos + Hiperface Encoder feedback
 Write access  CINH  OSC  P  RX  TX UNSIGNED_8