Lenze i700 - Manual (Page 62)

5 Motor control & motor settings
5.3 Wiring check by means of manual test modes
62
Lenze · i700 servo inverter · Reference manual · DMS 1.5 EN · 03/2014 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
5.3.1 Manual test mode "voltage/frequency"
Functional description
In this test mode, a rotating field voltage with the set output frequency f
out
is output at the motor
terminals after controller enable.
• If the frequency selection is positive, the motor should rotate clockwise when one is looking at
the A-side of the motor. If this is not the case, there is a simple rotating movement in the motor
phases.
• The level of the output voltage is determined via the following equation:
By means of the manual "Voltage/frequency" test mode, the wiring of the feedback system can also
be checked.
• If the feedback system is set correctly, the following actual speed should be shown:
Equation for calculating the output voltage
Axis A Axis B Symbol Description Dimension unit
0x2D82 0x3582 V
out
Current output voltage V
0x2835:2 0x3035:2 f
out
Output frequency for test mode Hz
0x2B01:1 0x3301:1 V
rated
V/f rated voltage V
0x2B01:2 0x3301:2 f
rated
V/f base frequency Hz
Greyed out = read access only
Equation for calculating the actual speed
Axis A Axis B Symbol Description Dimension unit
0x606C 0x686C n
act
Velocity actual value rpm
0x2835:3 0x3035:3 f
out
Output frequency for test mode Hz
0x2C01:1 0x3401:1 zp
Motor
Motor - number of pole pairs
Greyed out = read access only
U
out
f
out
U
rated
f
rated
--------------- ⋅
=
n
act
f
out
zp
motor
------------------- 60 ⋅
=