Westermo RedFox Series - Manual (Page 136)

Westermo OS Management Guide
Version 4.17.0-0
Use ”no timeout” to reset the timeout to default.
Default values 300 (seconds)
7.3.7 BOOTP source MAC address
Syntax [no] mac <offset <num> | address <MACADDRESS>>
Context System Bootstrap BOOTP context
Usage Set MAC address for BOOTP request. The source MAC-address used in
BOOTP request can be:
❼ offset relative to system base MAC: Typically used this if you wish your
product to use a MAC match the MAC of a specific LAN interface on your
unit.
❼ a statically configure MAC: Assign a specific MAC address to use for
BOOTP for this unit.
By default the source MAC is an offset to system base MAC, which would
match the MAC assigned to interface vlan1. On most WeOS products this
would mean ”mac offset 1” (exceptions are products with more than one
CPU channel; the offset equals the number of CPU channels by default).
Note
See sec. 7.3.2 and 13.4.14 for information on CPU base MAC and CPU
channels. For more information on how a LAN interface is assigned its
MAC address, see
section 19.2.4 .
Use ”no mac” to reset the BOOTP MAC setting to default.
Use ”show mac” to show the BOOTP MAC setting.
Default values offset 1 (or more generally, the offset equals the number of
CPU channels of the product.)
136 ➞ 2015 Westermo Teleindustri AB