Westermo RedFox Series - Manual (Page 571)

Westermo OS Management Guide
Version 4.17.0-0
24.3.8 Configure Ping Interval
Syntax [no] interval <SEC>
Context Alarm Trigger Configuration context
Usage Specify the interval between ICMP Ping.
Use command ”show interval” to show the ping trigger pinging interval
setting, i.e., interval of which ping messages are sent to probe the reacha-
bility to the peer.
24.3.9 Configure Ping Robustness Number
Syntax [no] number <NUM>
Context Alarm Trigger Configuration context (ping trigger)
Usage Specify the number of ICMP ping that should be lost (or received) to de-
termine if a host is unreachable (or reachable).
Use command ”show number” to show the ping trigger robustness number
setting, i.e., the number of pings required to be lost before the peer is con-
sidered unreachable, or the number of pings required to succeed before the
peer is considered reachable.
24.3.10 Configure Ping Outbound Interface
Syntax [no] outbound <IFNAME>
Context Alarm Trigger Configuration context (ping trigger)
Usage Force pings to use a specific outbound interface. This is very useful when
tracking upstreams connectivity in a VRRP dynamic priority scenario (see
section 30.1.1 ). Because then you want to make sure the default gateway,
or any other route, is avoided.
Use ”no outbound” to disable the setting. This makes ping rely on network
routes and fall back to use the default gateway.
Use command ”show outbound” to show the configured outbound interface
for this ping trigger. When unset, ”Default Gateway” is shown and the
➞ 2015 Westermo Teleindustri AB 571