Westermo RedFox Series - Manual (Page 299)

Westermo OS Management Guide
Version 4.17.0-0
Default values If no VLAN ”name” command is given, the VLAN name defaults
to vlanVID, e.g., vlan100 for VID 100.
13.4.9 Manage untagged ports
Syntax [no] untagged <PORT|PORTLIST>
Context VLAN Configuration context
Usage Associate port(s) with this VLAN VID in untagged mode. Only a single
VLAN VID can be associated untagged with each port. Ports associated with
a VLAN VID untagged will have that VID as default VID - this will have prece-
dence over any (fall-back) default VID configuration set in port context.
Use ”no untagged <PORTLIST>” to remove untagged ports from a VLAN. If
removal of an untagged port implies that the port is no longer associated
with any VLAN, that port will be configured to VLAN 1 untagged.
Use ”show untagged” to view ports associated untagged with this VLAN.
Default values Factory default lets all ports be associated with the default VLAN
(VLAN 1) untagged. For new VLANs, ports must explicitly be added.
Error messages ❼ A notification message is given in case the addition of port
as untagged on one VLAN implies that the same port will be removed
as untagged on another VLAN.
❼ A notification message is given in case the addition of port as untagged
on one VLAN implies that the same port will be removed as tagged on
the same VLAN (a port cannot be associated both tagged and untagged
with the same VLAN).
A ”PORTLIST” is a comma separated list of port ranges without intermediate
spaces, e.g., ”1/1-1/3,2/3”.
13.4.10 Manage tagged ports
Syntax [no] tagged <PORT|PORTLIST>
Context VLAN Configuration context
Usage Associate port(s) with this VLAN VID in tagged mode.
➞ 2015 Westermo Teleindustri AB 299