Westermo RedFox Series - Manual (Page 784)

Westermo OS Management Guide
Version 4.17.0-0
34.3 Managing GRE settings via the CLI
The table below shows GRE management features available via the CLI.
Command Default Section
Configure GRE settings
tunnel
Section 35.3.1
[no] gre <ID> Section 34.3.1
[no] enable Enabled Section 34.3.2
[no] local <IPADDR> Empty Section 34.3.3
[no] remote <IPADDR> Empty Section 34.3.4
[no] outbound <IFNAME> Auto Section 34.3.5
[no] ttl <TTL> Auto Section 34.3.6
Show GRE Status
show tunnel gre [ID]
Section 34.3.7
34.3.1 Managing GRE tunnels
Syntax [no] gre <ID> where ID is a number greater or equal to 1
Context Tunnel Configuration context
Usage Create, delete, or modify a GRE tunnel.
Use ”gre <ID>” to create a new GRE tunnel, or to enter the GRE Tunnel
Configuration context of an existing GRE tunnel. The ID affects the name
of the interface created for this tunnel. Example: ID as 1 will create an
interface named ”gre1”.
Use ”no gre <ID>” to remove a specific GRE tunnel, or ”no gre” to re-
move all configured GRE tunnels. This will also remove the corresponding
interfaces AND their configurations!
Use ”show [gre [ID]]” command within the Tunnel Configuration context.
Also available as ”show” command within the GRE Tunnel Configuration con-
text, and as ”show tunnel [gre [ID]]” within the Global Configuration
context.
Default values Not applicable.
784 ➞ 2015 Westermo Teleindustri AB