Westermo RedFox Series - Manual (Page 920)

Westermo OS Management Guide
Version 4.17.0-0
Context seroip context
Usage Multicast group to listen on. Note, this is only used in peer mode.
Default values Disabled (”no mcast-group”)
Error messages None defined yet.
39.3.14 Enabling Dynamic-peer
Syntax [no] dynamic-peer
Context seroip context
Usage Enable/disable dynamic-peer (The ”dynamic peer” setting is referred to
as ”latest calling” in Westermo EDW-100.)
Default values Disabled
Error messages None defined yet.
39.3.15 Setting AT Command Set
Syntax [no] atcmd-set <ID>
Context seroip context
Usage Select AT command set. This setting is only valid when Serial Over IP is
configured in AT command mode, see section 39.3.2 .
Use ”atcmd-set <ID>” to select an AT command set. AT command sets
are created via the ”atcmd <ID>” command, see
section 39.3.31 . (The AT
command set identifier (ID) can take values in range 1-5.)
Use ”no atcmd-set” to remove (disable) an AT command set selection.
Default values Disabled (”no atcmd-set”)
Error messages None defined yet.
39.3.16 Show All Settings of a Serial Over IP
Syntax show
920 ➞ 2015 Westermo Teleindustri AB