Westermo RedFox Series - Manual (Page 342)

Westermo OS Management Guide
Version 4.17.0-0
Use ”show synchronized” to show whether synchronized dual-homing is
enabled or disabled.
Default values Enabled
15.3.10 Managing Multi-Link Dual-Homing Uplink Ports
Syntax [no] uplink [PORT]
Context Dual-Homing Configuration context
Usage Use ”uplink PORT” to define the given port as uplink for this dual-homing
node, and enter the Dual-Homing Uplink Configuration context for the port.
A port can be an Ethernet port (
chapter 8 ), a DSL port ( chapter 10 and chap-
ter 11 ), or a link aggregate ( chapter 17 ).
Up to MAX_DUAL_HOMING_UPLINKS ( section 15.4 ) can be created.
Use ”no uplink PORT” to remove the give port as uplink for this dual-
homing node, or use ”no uplink” to remove all uplinks for the node.
Use ”show uplink” to list configuration information for all uplinks, and ”show
uplink PORT” to list uplink configuration settings for the given port (also
available as ”show” command within the Dual-Homing Uplink Configuration
context for the port.)
Default values Not applicable
15.3.11 Set Multi-Link Dual-Homing Uplink Path-Cost
Syntax [no] path-cost <auto|COST>
Context Dual-Homing Uplink Configuration context
Usage Configure uplink path-cost. By default, the path-cost depends on the link
speed and duplex mode (higher speed gives lower cost). It is also possible
to set a cost manually in range 1..2
32 -1 (1..4294967295).
The path-cost is used when electing the active uplink – the link with the
lowest cost will be the active uplink. If the costs of two uplinks are equal,
their uplink priority (
section 15.3.12 ) is considered. For more details, see
section 15.1.3 .
342 ➞ 2015 Westermo Teleindustri AB