Westermo RedFox Series - Manual (Page 52)

Westermo OS Management Guide
Version 4.17.0-0
Example
example:/config/vlan-100/#> help
Available Commands
==============================================================================
enable
Enable, or disable this VLAN
name <ARG> Set name of VLAN
tagged <ARG> Set tagged ports
untagged <ARG> Set untagged ports
channel <ARG> Set VLAN channel interface
priority <ARG> Set VLAN priority, overrides port priority
igmp Enable, or disable IGMP Snooping
show enable Show if VLAN is active or not
show name Show name of VLAN
show tagged Show tagged ports
show untagged Show untagged ports
show channel Show VLAN channel interface
show priority Show VLAN priority setting
show igmp Show IGMP Snooping status
no <ARG> Prefix, used to disable services or settings.
do Shortcut to EXEC mode, e.g. do ping <IP>.
end Save settings and return to previous mode.
leave Save settings and return to EXEC mode.
abort Cancel all changes and leave this mode.
show <ARG> Show summary, or status.
repeat <ARG> Repeat next command every second, until Ctrl-C
help <ARG> This help text.
tutorial Brief introduction to the CLI
==============================================================================
<ARG> - Command takes argument(s), see help <command> for further information.
Short forms of commands are possible, see the tutorial for more help.
example:/config/vlan-100/#>
Figure 5.2: Use of the ”help” command to list available commands (here in the
VLAN context).
The ”help” command can also be used to get information on a specific command
as shown below.
Example
example:/config/vlan-100/#> help igmp
Syntax:
[no] igmp
Description:
Enable, or disable IGMP Snooping
==============================================================================
The [no] keyword is when you want to disable a service or remove a property.
example:/config/vlan-100/#>
52 ➞ 2015 Westermo Teleindustri AB