Westermo RedFox Series - Manual (Page 252)

Westermo OS Management Guide
Version 4.17.0-0
– Use ”mode adsl annex <a|i|l|m|l-m>” to specify ADSL mode over
a POTS carrier network.
– Use ”mode adsl annex <b|j>” to specify ADSL mode over an ISDN
carrier network.
– For further information on ADSL Annex settings, see section 11.1.1 .
When selecting ADSL mode, the ADSL specific settings ”encap” ( sec-
tion 11.3.4 ) and ”pvc” ( section 11.3.5 ) are enabled.
❼ VDSL:
– Use ”mode vdsl annex a” to specify VDSL mode over a POTS car-
rier network.
– Use ”mode vdsl annex b” to specify VDSL mode over an ISDN car-
rier network.
– Use ”mode vdsl annex a-b” to auto-detect whether your VDSL con-
nection is over a POTS or ISDN carrier. This alternative is usually
preferable for VDSL connections due to its simplicity, but the auto-
detection mechanism may experience problems on long copper ca-
bles. If this is the case, please try ”mode vdsl annex a” or ”mode
vdsl annex b” depending on the carrier type of your VDSL connec-
tion.
Use ”no mode” to reset the mode setting to the default value.
Use ”show mode” to show whether the xDSL port is set to operate as ADSL or
VDSL port, and the type of carrier network used, Annex A, Annex I, Annex L
or Annex M (POTS) or Annex B or Annex J (ISDN). Annex I and J not supported
in VDSL mode.
Default values ADSL over POTS (”mode adsl annex a”)
11.3.3 Specify whether external splitter is used or not
Syntax [no] filter
Context xDSL Port Configuration context
Usage Specify whether a (external) splitter is used or not, i.e., is the Falcon unit
connected directly to the telephone jack or via a splitter.
252 ➞ 2015 Westermo Teleindustri AB