Section 19.2.5 – Westermo RedFox Series User Manual

Page 401

Advertising
background image

Westermo OS Management Guide

Version 4.17.0-0

4. Use the MAC address of the channel (

section 13.1.6

) associated with the

VLAN.

Consider the sample configuration in

fig. 19.1

. When all interfaces get their MAC

address automatically, interface vlan1 inherits the MAC address of port 1, vlan2
inherits its MAC from port 4, vlan3 from port 7 (assuming port 6 is tagged on
VLAN 3), and interface vlan4 from port 10.

Note

For the automatic MAC assignment methods (steps

2

-

4

above), the MAC ad-

dress may change when the set of ports associated with the VLAN changes.
When this happens, the WeOS device will submit a gratuitous ARP to update
stale ARP caches in neighbour nodes.

For VLANs created dynamically (

section 13.1.7

), no associated network interface

is created. Thus, for such VLANs no interface MAC address is needed.

19.2.5

IP address settings

Each network interface can be assigned a primary IP address and up to 8 sec-
ondary
IP addresses, this is sometimes referred to as multinetting, but can also
be another address on the same subnet as the primary address. The primary IP
address can either be statically or dynamically assigned, depending on the ad-
dress method configured for the interface (”inet static” or ”inet dynamic”).

The secondary IP addresses can only be statically configured, but can be used
with both static and dynamic primary address.

Options for configuring the primary address for different interface types:

VLAN interfaces: The primary IP address of a VLAN interface can be config-

ured statically, or configured to acquire its address dynamically (DHCP). It is
also possible to have a VLAN interface without any IP address.

PPP interfaces: For PPP interfaces the address setting is set to dynamic, but

the actual IP address assignment is handled by the PPP configuration (IPCP),
see

section 33.1.7

.

GRE interfaces: For GRE interfaces, the primary IP address can only be con-

figured statically.

Loopback interface (lo): The primary IP address of the loopback interface

(lo) is permanently set to 127.0.0.1.

➞ 2015 Westermo Teleindustri AB

401

Advertising
This manual is related to the following products: