Westermo RedFox Series - Manual (Page 425)

Westermo OS Management Guide
Version 4.17.0-0
Use ”show enable” to show whether this interface is configured as admin-
istratively enabled (up) or disabled (down).
Default values Enabled (”enable”)
19.6.3 IP Addresses (primary and secondary)
Syntax [no] address <ADDRESS/LEN|ADDRESS NETMASK> [secondary]
Context Interface Configuration context
Usage Set static IP address and netmask for an interface.
When static address assignment is chosen (”inet static”, see section 19.6.1 ),
the ”address” command can be used to the primary IP address of the
interface, as well as secondary IP addresses of the interface (using the
”secondary”) keyword.
When dynamic address assignment is chosen (”inet dynamic”, see sec-
tion 19.6.1 ), the ”address” command is limited to assign secondary IP ad-
dresses.
Up to 8 secondary addresses can be configured for an interface.
It is possible to specify the boundary between the network part and the
host specific part of the IP address either as a prefix length (e.g. ”address
192.168.0.1/24”) or as a regular netmask (e.g., ”address 192.168.0.1
255.255.255.0”).
Use ”show address” to show the IP address setting for this interface.
Default values Disabled (no address). That is, newly created interfaces have
no IP address configured, see also section 19.2.3 .
19.6.4 Primary Interface
Syntax [no] primary
Context Interface Configuration context
Usage This command is deprecated and only kept for backwards compatibility
when upgrading. It is recommend to instead use the interface admin dis-
tance setting (
section 19.6.5 ).
➞ 2015 Westermo Teleindustri AB 425