Westermo RedFox Series - Manual (Page 423)

Westermo OS Management Guide
Version 4.17.0-0
19.6 Managing network interfaces via the CLI
The available interface settings and monitoring commands are shown in the table
below:
Command Default Section
iface <IFNAME> inet <static|dynamic> Differs 1 Sec. 19.6.1
[no] enable [always] Enabled Sec. 19.6.2
[no] address <ADDRESS/LEN| Disabled Sec. 19.6.3
ADDRESS NETMASK> [secondary]
[no] primary DEPRECATED Sec. 19.6.4
[no] distance <1-255> 16 Sec. 19.6.5
[no] management <[ssh] [telnet] [http] Enabled 2 Sec. 19.6.6
[https] [ipconfig] [snmp] | all>
[no] mtu <68-1500> Differs 1 Sec. 19.6.8
[no] tcp-mss <40-1460|auto> Differs 1 Sec. 19.6.9
[no] redirect Enabled Sec. 19.6.10
Only for VLAN interfaces
[no] mac <X:X:X:X:X:X>
Auto Sec. 19.6.7
Show interface status
show iface [IFNAME]
Sec. 19.6.11
19.6.1 Manage Network Interfaces
Syntax iface <IFNAME> inet <static|dynamic>
Context Global Configuration context
Usage Enter Interface Configuration context, and specify IP address assignment
method.
❼ ”static” means static IP address assignment. The IP address is config-
ured via the ”[no] address <ADDRESS/LEN|ADDRESS NETMASK>” com-
1 Some interface ”native” default settings depend on the interface type, see section 19.2.3 .
Section 19.2.2 provides information on ”factory” default settings.
2 By default, all management services except Telnet are allowed on newly created VLAN and
PPP interfaces.
➞ 2015 Westermo Teleindustri AB 423