Westermo RedFox Series - Manual (Page 68)

Westermo OS Management Guide
Version 4.17.0-0
level authNoPriv is used where SHA1 is used as authentication protocol.
Example
example:/#> configure
example:/config/#> snmp-server
example:/config/snmp/#> rouser alice auth sha1 alicepwd
example:/config/snmp/#> leave
example:/#> cp running start
Section 6.1.6 lists recommended SNMP management software. Those tools have
graphical user interfaces and should be straight forward to use. For a simple
test you could also use the (Unix) Net-SNMP ”snmpwalk” command. (Here it
is assumed that the switch is accessible on IP address 192.168.2.200 and the
”walk” is limited to the mib-2 system’s group).
Example
mypc:~$ snmpwalk -v3 -u alice -l authNoPriv -a SHA -A alicepwd 192.168.2.200 system
SNMPv2-MIB::sysDescr.0 = STRING: Westermo RedFox Industrial, primary: v4.4.0, backup: v4.
bootloader: v2.01, fpga: v20080626
SNMPv2-MIB::sysObjectID.0 = OID: SNMPv2-SMI::enterprises.16177
DISMAN-EVENT-MIB::sysUpTimeInstance = Timeticks: (94018) 0:15:40.18
SNMPv2-MIB::sysContact.0 = STRING:
SNMPv2-MIB::sysName.0 = STRING: redfox
SNMPv2-MIB::sysLocation.0 = STRING:
SNMPv2-MIB::sysServices.0 = INTEGER: 79
SNMPv2-MIB::sysORLastChange.0 = Timeticks: (0) 0:00:00.00
mypc:~$
6.1.5 Supported MIBs
6.1.5.1 Standard MIBs
As of WeOS v4.17.0 the following standard MIBs are supported:
❼ RFC1213 MIB-2: The original MIB-2 standard MIB.
❼ RFC2863 Interface MIB: The ifXTable of the IF-MIB is supported.
❼ RFC2819 RMON MIB: RMON Ethernet statistics (etherStatsTable) is supported.
❼ RFC4188 Bridge MIB
❼ RFC4318 RSTP MIB
❼ RFC4363 Q-BRIDGE MIB: The dot1qVlan group and dot1qVlanStaticTable are
supported, enabling support for static VLAN configuration.
68 ➞ 2015 Westermo Teleindustri AB