Westermo RedFox Series - Manual (Page 181)

Westermo OS Management Guide
Version 4.17.0-0
8.3 Managing port settings via the CLI
The port configuration context can be entered using the ”port <PORT|PORTLIST>”
command from the Global Configuration context. When providing a list of ports,
the scope of the configuration commands becomes all ports in the list. There is
also a specific command, ”ports”, to enter the port context with the scope of all
Ethernet ports of the device.
Command Default Section
port [eth|. . . ] <PORTLIST> Ethernet Section 8.3.1
ports [eth|. . . ] Ethernet Section 8.3.2
[no] enable Enabled Section 8.3.3
[no] speed-duplex <auto|10-half|10-full| auto Section 8.3.4
100-half|100-full|. . . >
[no] flow-control Disabled Section 8.3.5
[no] priority <0-7> 0 Section 8.3.6
[no] priority-mode <tag|ip|port> tag Section 8.3.7
[no] link-alarm Disabled Section 8.3.8
[no] rate-limit <64-1000000> Disabled Section 8.3.9
[match <TYPE>[,<TYPE>,...]]
[no] traffic-shaping <<64-1000000>| Disabled Section 8.3.10
<7700-1488000> fps>
[no] mdix-mode <auto|mdi|mdix> auto Section 8.3.11
[no] unshielded Unshielded Section 8.3.12
[no] low-power Low Power Section 8.3.13
[no] default-vid <VLAN_ID> Disabled Section 8.3.14
Show port status
show ports
Section 8.3.15
Show SFP DDM/DOM diagnostics
show environment
Section 7.3.50
➞ 2015 Westermo Teleindustri AB 181