Westermo RedFox Series - Manual (Page 914)

Westermo OS Management Guide
Version 4.17.0-0
Continued from previous page
Command Default Section
[no] atcmd-set <ID> Disabled Section 39.3.15
Show Serial Over IP settings
seroip
show Section 39.3.16
show mode Section 39.3.17
show port Section 39.3.18
show protocol Section 39.3.19
show atcmd-set Section 39.3.20
show listen Section 39.3.21
show listen-secondary Section 39.3.22
show secondary-mode Section 39.3.23
show dtr-control Section 39.3.24
show mcast-group Section 39.3.25
show frame-separator Section 39.3.26
show frame-delay Section 39.3.27
show frame-size Section 39.3.28
show peer Section 39.3.29
show dynamic-peer Section 39.3.30
Configure AT Command profiles
[no] atcmd [ID]
1 Section 39.3.31
[no] auto-answer <COUNT> 1 Section 39.3.32
[no] echo Enabled Section 39.3.33
[no] verbose Enabled Section 39.3.34
[no] sync-connect Disabled Section 39.3.35
[no] sync-timeout <TIMEOUT> 60 s Section 39.3.36
[no] ok-message text <MESSAGE> OK Section 39.3.37
code <CODE> 0
[no] error-message text <MESSAGE> ERROR Section 39.3.38
code <CODE> 4
[no] connect-message text CONNECT Section 39.3.39
<MESSAGE> code <CODE> 1
[no] disconnect-message text NO CARRIER Section 39.3.40
Continued on next page
914 ➞ 2015 Westermo Teleindustri AB