Westermo RedFox Series - Manual (Page 721)

Westermo OS Management Guide
Version 4.17.0-0
Continued from previous page
New Rule Click this button to create a new packet filter rule. You
will be presented to a form where you can configure the
new rule.
Select Check this box to select one or a set of rules for group rule
management. Check the Select all box at the bottom of
the page to select all rules.
Order The order in which the rules will be applied. When using a
JavaScript enabled browser, it is possible to select one or
more rules and perform an action on multiple rules, see
below. If not using a JavaScript enabled browser, there
will be a set of arrows available to move rules up or down
to change the order of application.
Active A green check-mark means the rule is active, and a dash
means it is inactive.
Policy The type of rule, Allow or Deny.
In Interface The rule will be applied to traffic entering on this inter-
face.
Out Interface The rule will be applied to traffic exiting on this interface.
If neither Out Interface nor Destination Address (see be-
low) are specified, the rule will apply to the INPUT chain,
i.e., traffic destined to the switch itself (ICMP pings, SSH
management, etc.).
Source
Address(es) The rule will be applied to traffic originating from a source
with this specific IP-address or an IP-address in the speci-
fied subnet.
Destination
Address(es) The rule will be applied to traffic destined to this specific
IP-address or to an IP-address in the specified subnet. If
neither Out Interface (see above) nor Destination Address
are specified, the rule will apply to the INPUT chain, i.e.,
traffic destined to the switch itself (ICMP pings, SSH man-
agement, etc.).
Destination
Port The rule will be applied to traffic destined to this set of
(UDP/TCP) ports.
Protocol The rule will be applied to traffic using this protocol. Se-
lect the protocol name or enter the protocol number. If
ANY the rule will be applied for all protocol types.
Continued on next page
➞ 2015 Westermo Teleindustri AB 721