Westermo RedFox Series - Manual (Page 867)

Westermo OS Management Guide
Version 4.17.0-0
Context SSL VPN Configuration context
Usage Set the outbound interface of this tunnel.
Use ”no outbound” to automatically select the interface leading to the de-
fault gateway as outbound interface.
Use ”show outbound” to show the configured outbound interface for this
tunnel. ”Default Gateway” is shown if the interface leading to the default
gateway should be used as outbound interface.
Default values Auto (”no outbound”)
36.3.19 Change keepalive settings
Syntax [no] keepalive <interval <SEC> restart <SEC>>
Context SSL VPN Configuration context
Usage Send keepalive probes over the tunnel to make sure that stateful firewalls
gets updated as expected, they is only sent as long as there is no traffic on
the tunnel.
❼ interval - The interval to send probes, if there are not traffic on
❼ restart - Force restart of the ping probe, this will force reload of DNS for
example, this is very useful when dealing with DynDNS ( section 19.3.3 ).
Note: In server mode, this settings will also be pushed to the clients, if
”pull” is enabled in the clients, they will not need to configure keepalive
settings.
Use ”show keepalive” to view current keepalive settings.
Default values interval 10 restart 60
36.3.20 Configure compression settings
Syntax [no] compression [adaptive]
Context SSL VPN Configuration context
Usage Toggle compression settings, ”no compression” will disable all compres-
sion. ”compression adaptive” will result in that SSL VPN tries to find out
if the traffic is encrypted, if not it will encrypt it. This will have performance
➞ 2015 Westermo Teleindustri AB 867