Westermo RedFox Series - Manual (Page 822)

Westermo OS Management Guide
Version 4.17.0-0
Use ”show ipsec <INDEX>” to show all settings of a specific IPsec tunnel
(also available as ”show” command within the
IPsec Configuration context).
Note
Tunnels which are not intended to be used should either be deleted or
disabled (
section 35.3.5 ).
Default values Not applicable.
35.3.5 Enable/disable an IPsec VPN tunnel
Syntax [no] enable
Context IPsec Configuration context
Usage Enable or disable an IPsec VPN tunnel. A disabled tunnel will be deacti-
vated, but keeps its configuration settings.
Use ”enable” to enable and ”no enable” to disable an IPsec VPN tunnel.
Use ”show enable” to show whether this IPsec tunnel is enabled or dis-
abled.
Note
Tunnels which are not intended to be used should either be deleted
(
section 35.3.4 ) or disabled.
Default values Enabled
35.3.6 IKE phase-1 aggressive or main mode
Syntax [no] aggressive
Context IPsec Configuration context
Usage Select aggressive or main mode for the IKE phase-1 handshake.
Use ”aggressive” to select aggressive mode, and ”no aggressive” to se-
lect main mode.
Use ”show aggressive” to show whether this IPsec tunnel is configured
to use IKE aggressive or main mode. ”Enabled” means aggressive mode,
while ”Disabled” means main mode.
822 ➞ 2015 Westermo Teleindustri AB