Westermo RedFox Series - Manual (Page 585)

Westermo OS Management Guide
Version 4.17.0-0
Use ”console” to enable console logging, and ”no console” to disable con-
sole logging.
When enabled, general events detected by the system, as well as alarm
events associated with configured alarm triggers, will be presented on the
console port.
Use ”show console” to show whether console port logging is enabled or
disabled.
Default values Disabled
25.2.3 Logging to remote syslog server
Syntax [no] server <ADDRESS1 [ADDRESS2]>
Context Logging Configuration context
Usage Set remote syslog server(s) (IPv4 addresses). A maximum of two remote
syslog servers are supported. The syntax allows typing them in one line or
two separate lines.
Use ”no server <ADDRESS>” to remove a single server. Use ”no server”
to remove all servers.
When enabled, general events detected by the system, as well as alarm
events associated with configured alarm triggers, will be forwarded to the
configured syslog server via UDP to port 514. If two servers are configured,
messages are sent to both of them.
Use ”show server” to show whether remote syslog logging is enabled or
disabled. If enabled, the IP address(es) of the configured server(s) are pre-
sented.
Default values Disabled
➞ 2015 Westermo Teleindustri AB 585