Westermo RedFox Series - Manual (Page 222)

Westermo OS Management Guide
Version 4.17.0-0
Use ”show ghs-threshold” to show the SHDSL port’s G.HS Threshold set-
ting.
Default values Disabled (”no ghs-threshold”)
10.3.6 Setting SHDSL PAF mode
Syntax [no] paf
Context SHDSL Port Configuration context
Usage Set the SHDSL unit to operate in paf mode.
PAF aggregates the 2 SHDSL ports to achieve higher bandwidth. The func-
tionality demands that the rate do not differ more than 4 times between
port 1 and 2 to ensure good performance. Port 2 must be configured to the
same role (CO/CPE) as port 1 to get the functionality working.
Note
This functionality is only available on DDW-142 and DDW-142-485.
Use ”show paf” to show whether PAF is enabled or not.
Default values Disabled
10.3.7 Setting SHDSL low jitter mode
Syntax [no] low-jitter
Context SHDSL Port Configuration context
Usage Set the SHDSL unit to operate in low jitter mode.
Low Jitter can be enabled to minimize the jitter of the latency over the
SHDSL link in applications where high accuracy of the Ethernet packet jitter
is needed. This functionality is using a different SHDSL mode compared to
default setting, thus the Low Jitter configuration must be set on both SHDSL
ports sharing the physical cable.
Use ”show low-jitter” to show the SHDSL port’s low-jitter setting.
Default values Disabled
222 ➞ 2015 Westermo Teleindustri AB