Westermo RedFox Series - Manual (Page 888)

Westermo OS Management Guide
Version 4.17.0-0
38.3 Managing serial ports via the CLI interface
The table below shows serial port management features available via the CLI.
Command Default Section
Configure common serial port settings
port [serial|. . . ] <PORTLIST>
Section 38.3.1
[no] speed <50-2000000> 115200 Section 38.3.2
[no] databits <7-8> 8 Section 38.3.3
[no] parity Disabled Section 38.3.4
[no] stopbits 1 Section 38.3.5
[no] xonxoff Disabled Section 38.3.6
Configure settings specific to RS-232
[no] rtscts Disabled Section 38.3.7
Configure settings specific to RS-232/422/485 and RS-422/485 ports combo ports
[no] type <rs232|rs422|rs485> Differs 1 Section 38.3.8
[no] terminate [rx] [tx] Disabled Section 38.3.9
Configure settings specific to RS-232/422/485 combo ports
[no] enable Disabled Section 38.3.10
Show serial port status
show port serial [PORTLIST]
Section 38.3.11
1 Default for RS-232/422/485 ”combo” ports is ”rs232”, while default for RS-422/485 ”combo”
ports is ”rs485”.
888 ➞ 2015 Westermo Teleindustri AB