Westermo RedFox Series - Manual (Page 185)

Westermo OS Management Guide
Version 4.17.0-0
8.3.5 Flow-control setting
Syntax [no] flow-control
Context Ethernet Port Configuration context.
Usage Enable or disable IEEE 802.3 flow-control. For full duplex links, flow con-
trol will utilise IEEE 802.3 pause frames, and for half duplex links a technique
known as back-pressure is used.
The flow control setting is only valid when the speed-duplex mode is set to
”auto”, see
section 8.1.2 .
Use ”show flow-control” to show the port’s flow-control setting.
Default values Disabled (no flow-control)
8.3.6 Port priority setting
Syntax [no] priority <0-7>
Context Ethernet Port Configuration context (also available in SHDSL Port Con-
figuration and xDSL Port Configuration for products with DSL ports)
Usage Set the (IEEE 802.1p) priority associated with the port. Packets coming
in on this port will receive this priority unless priority is based on VLAN ID,
VLAN tag or IP ToS/DiffServ bits.
”no priority” will revert to default configuration for the port priority set-
ting, i.e., ”priority 0” (zero).
Use ”show priority” to show the port’s priority setting.
Default values 0 (zero)
8.3.7 Set port priority mode
Syntax [no] priority-mode <tag|ip|port>
Context Ethernet Port Configuration context (also available in SHDSL Port Con-
figuration and xDSL Port Configuration for products with DSL ports)
➞ 2015 Westermo Teleindustri AB 185