Westermo RedFox Series - Manual (Page 158)

Westermo OS Management Guide
Version 4.17.0-0
Example
example:/#> config
example:/config/#> show ipconfig
Ipconfig is enabled
Read only mode : Disabled
example:/config/#> no ipconfig
Deactivating ipconfig service.
example:/config/#> end
7.3.47 Enable/Disable configuration and upgrade via IPConfig ser-
vice
Syntax [no] read-only
Context IPConfig Configuration context.
Usage The IPConfig service (used by the WeConfig tool) can be used to discover
and view status of a unit, but also for some simple configuration (IP address,
netmask and default gateway) and firmware upgrade (primary firmware).
By setting IPConfig in ”read-only” mode, no configuration or firmware up-
grade is possible via IPConfig service.
Use ”show read-only” to list whether ’read-only’ is enabled or disabled.
Use ”read-only” to activate ’read-only’ mode, and ”no read-only” to set
the mode to ’read/write’.
Default values Disabled (”no read-only”, i.e., configuration and upgrading
via IPconfig service is possible.)
Examples How to limit IPConfig service to ’read-only’. That is, disabling config-
uration and upgrading of the unit via IPConfig, while allowing use of IPConfig
to discover the unit and status information retrieval.
Example
example:/#> config
example:/config/#> show ipconfig
Ipconfig is enabled
Read only mode : Disabled
example:/config/ipconfig/#> read-only
Setting IPconfig read only mode Enabled
example:/config/ipconfig/#> end
158 ➞ 2015 Westermo Teleindustri AB