Westermo RedFox Series - Manual (Page 184)

Westermo OS Management Guide
Version 4.17.0-0
Example
example:/config/#> show ports dsl
xDSL -------------------------------------------- Priority ---- Limit - Default
Port
Ena Mode Filter Encap PVC Annex Alarm Mode Level In | Out Vid
===============================================================================
DSL 1
YES adsl YES llc 8/35 A NO tag 0 None None Auto
===============================================================================
example:/config/#>
8.3.3 Port enabling and disabling
Syntax [no] enable
Context Ethernet Port Configuration context (also available in SHDSL Port Con-
figuration and xDSL Port Configuration for products with DSL ports)
Usage Use ”enable” to enable and ”no enable” disable a port.
Use ”show enable” to show whether the port is enabled or disabled.
Default values Ports are enabled by default.
8.3.4 Speed and duplex setting
Syntax [no] speed-duplex <auto|10-half|10-full|100-half|100-full|
1000-half|1000-full>
Context Ethernet Port Configuration context.
Usage Set port speed and duplex modes. ”auto” means auto-negotiate, other
modes are static configurations specifying 10, 100 or 1000 Mbit/s, and half
or full duplex.
”no speed-duplex” will revert to default configuration for the speed-duplex
setting, i.e., ”speed-duplex auto”.
Use ”show speed-duplex” to show the port’s speed/duplex setting.
Default values auto
Error messages An attempt to set a port speed not available for this specific
port type will render an error message, including information of available
port speeds.
184 ➞ 2015 Westermo Teleindustri AB