Westermo RedFox Series - Manual (Page 442)

Westermo OS Management Guide
Version 4.17.0-0
Default values Not applicable.
19.7.23 Set NTP Client (Remote) Server Address (deprecated)
Syntax [no] server <FQDN|IPADDR>
Context NTP Client Configuration context
Usage Set IP Address, or domain name, of NTP Server used by this client.
A single NTP server IP address, or a fully qualified domain name, FQDN, can
be configured. If disabled, NTP server can be acquired dynamically from an
interface with DHCP address assignment.
”no server” to remove a configured NTP server address.
Use ”show server” to show NTP client (remote) server setting.
Note
The ”server” command within NTP Client Configuration context is dep-
recated and kept for backwards compatibility. NTP client settings for
remote server is instead handled as part of other NTP settings in the
NTP Remote Server Configuration , see section 19.7.19 .
Default values Disabled
19.7.24 Set NTP Poll Interval (deprecated)
Syntax [no] poll-interval <30-720>
Context NTP Client Configuration context
Usage Set NTP server poll interval (in seconds). ”no poll-interval” will reset
the poll interval to its default (600 seconds).
Use ”show poll-interval” to show configured poll interval.
Note
The ”poll-interval” command within NTP Client Configuration con-
text is deprecated and kept for backwards compatibility. NTP client set-
tings for remote server is instead handled as part of other NTP settings
in the
NTP Remote Server Configuration , see section 19.7.21 .
442 ➞ 2015 Westermo Teleindustri AB