Westermo RedFox Series - Manual (Page 220)

Westermo OS Management Guide
Version 4.17.0-0
Usage Set SHDSL port rate, either bye specifying that auto-negotiation should
be used, or that a specific fixed rate should be used. Only the ”speed”
setting on the CO has affect on the established connection.
❼ Auto-negotiate: Use ”speed auto”, ”speed 0”, or ”no speed” to let
the rate be auto-negotiated between the SHDSL nodes in the extended
SHDSL range 32-15288 kbps on Turbo HW; if not Turbo HW the range is
192-5696 kbps.
Use ”speed auto-5696k” to let the rate be auto-negotiated in the stan-
dard SHDSL range 192-5696 kbit/s.
❼ Fixed rate: Use ”speed RATE”, where RATE is in range ”1k-15304k” on
products with Turbo-HW support, and in range ”1k-5096k” on products
without Turbo-HW support, to specify a fixed data rate in kbit/s. Alter-
natively, specify ”speed 1-15304000” and ”speed 1-5696000” respec-
tively, to specify a fixed data rate in bit/s.
The following fixed rates are supported on all SHDSL products: 192k,
384k, 512k, 768k, 1024k, 1280k, 2048k, 2304k, 2688k, 3072k, 3456k,
3840k, 4224k, 4608k, 4992k, 5376k, and 5696k.
Products with Turbo-HW support the following additional fixed data rates:
32k, 64k, 128k, 6200k, 6712k, 7224k, 7736k, 8248k, 8760k, 9272k,
9784k, 10296k, 10808k, 11320k, 11832k, 12344k, 13112k, 13880k,
14648k and 15304k.
If other rates are specified, WeOS will round the value upwards to the
nearest supported rate.
Use ”show speed” to show the SHDSL port’s rate setting.
Default values ”speed auto”
10.3.4 Setting SHDSL port noise-margin
Syntax [no] noise-margin <reliable|normal|high-speed [nonstrict]>
Context SHDSL Port Configuration context
Usage Set SHDSL port noise-margin. Note: The noise-margin setting is only
relevant when the data rate is set to auto-negotiate (”rate 0”), see sec-
tion 10.3.3 ).
Available noise-margin modes:
220 ➞ 2015 Westermo Teleindustri AB