Westermo RedFox Series - Manual (Page 625)

Westermo OS Management Guide
Version 4.17.0-0
Use the ”range <NETWORK/LEN>” (”range <NETWORK/LEN> advertise” is
equivalent) to aggregate routes (within this area) matching the specified
<NETWORK/LEN> range, before distributing the routes outside this area.
That is, all routes within this range are summarised as a single route, when
advertised outside this area.
Use the ”range <NETWORK/LEN> not-advertise” to prohibit routes (within
this area) matching the specified <NETWORK/LEN> range, to be distributed
outside this area. That is, routes within this range are filtered.
Use ”no range <NETWORK/LEN>” to remove a specific summary/filter set-
ting, or ”no range” to remove all summary/filter settings for this area.
Use ”show default-cost” to show configured route summarisation and
route filtering settings for this area.
Default values Disabled
27.3.14 Manage Interface Specific OSPF Settings
Syntax [no] ospf
Context Interface Configuration context
Usage Enter the Interface OSPF Configuration context, i.e., the context where
Interface specific OSPF settings are configured.
Use ”no ospf” to remove any specific OSPF settings for this interface.
Use ”show ospf” to show a summary of OSPF settings for this interface.
(Also available as ”show” command within the
Interface OSPF Configuration
context.)
Default values Disabled (i.e., no interface specific OSPF settings)
27.3.15 Configure Interface OSPF Passive Settings
Syntax [no] passive [auto]
Context Interface OSPF Configuration context
Usage Control whether a specific interface should be passive (”passive”), ac-
tive (”no passive”), or to automatically follow (”passive auto”) the global
➞ 2015 Westermo Teleindustri AB 625