Westermo RedFox Series User Manual
Page 398
Westermo OS Management Guide
Version 4.17.0-0
Interface parameters
Factory Default Setting (Falcon)
vlan1
vlan1006
lo
Administrative Mode
Enabled
Enabled
Enabled
IP address
Static
Dynamic
Static
192.168.2.200
(DHCP)
127.0.0.1
Netmask
255.255.255.0
N/A
255.0.0.0
Secondary IP addresses
Disabled
Disabled
Disabled
MAC address
Auto
Auto
N/A
MTU
Auto (1500)
Auto (1500)
16436
TCP-MSS
Disabled
Disabled
Disabled
Admin Distance
16
1
16
Management Interface
Enabled
1
Disabled
Disabled
Note
On Falcon, the xDSL port associated with VLAN 1006 is intended to be used
as the upstream ”WAN” port for Internet access. Interface vlan1006 inherits
its admin distance from the base interface, which by default is 1. For security
reasons, management services are filtered out on vlan1006 by default.
19.2.3
Creating Additional Network Interfaces
As shown in
the switch will have one network interface for every VLAN
defined on the switch. Thus, additional VLAN network interfaces can be created
by creating new VLANs (see
). Similarly, a PPP network interface is
created for every configured PPP instance, a GRE network interface is created for
every configured GRE instance, etc.
The default settings for new VLAN and PPP (PPPoE and PPP over serial/modem)
interfaces are shown in the table below, followed by a table presenting default
settings for GRE and SSL VPN interfaces (PPP, GRE and SSL VPN interfaces are
available for products running software level WeOS Extended).
It is not possible to create additional loopback interfaces. To have additional
loopback IP addresses you can instead configure secondary IP addresses on the
lo interface.
1
At factory default, all management services except Telnet are allowed on interface vlan1.
398
➞ 2015 Westermo Teleindustri AB