Westermo RedFox Series - Manual (Page 218)

Westermo OS Management Guide
Version 4.17.0-0
10.3 Managing SHDSL ports via the CLI
The table below shows SHDSL port management features available via the CLI.
Command Default Section
Configure SHDSL port settings
port [dsl|shdsl|. . . ] <PORTLIST>
Section 10.3.1
[no] co Section 10.3.2
[no] speed <auto|auto-5696k|0-15304k> Auto Section 10.3.3
[no] noise-margin Normal Section 10.3.4
[no] ghs-threshold <low|medium|high> Disabled Section 10.3.5
[no] paf Disabled Section 10.3.6
[no] low-jitter Disabled Section 10.3.7
[no] emf Enabled Section 10.3.8
Port settings in common with Ethernet ports ( chapter 8 )
[no] enable Enabled Section 8.3.3
[no] priority <0-7> 0 Section 8.3.6
[no] priority-mode <tag|ip|port> tag Section 8.3.7
[no] link-alarm Disabled Section 8.3.8
[no] rate-limit <70-2560> Disabled Section 8.3.9
[no] traffic-shaping <70-2560> Disabled Section 8.3.10
[no] default-vid <VLAN_ID> Disabled Section 8.3.14
Show SHDSL related status and statistics
show <dsl|shdsl>
Section 10.3.9
show ports Section 8.3.15
show rmon Section 9.3
10.3.1 Managing SHDSL port settings
Syntax port [dsl|shdsl|...] <PORTLIST>
Context Global Configuration context
218 ➞ 2015 Westermo Teleindustri AB