3 managing alarms via the cli – Westermo RedFox Series User Manual
Page 553
Westermo OS Management Guide
Version 4.17.0-0
24.3
Managing Alarms via the CLI
The table below shows alarm management features available via the CLI.
Command
Default
Section
Configure Alarm Configuration Settings
alarm
[no] trigger <<INDEX> | <TYPE>>
[no] enable
Enabled
[no] <port <PORTLIST> |
sensor <SENSORIDLIST> |
ring <FRNTINSTANCE>
timeout <TIMESPEC>
peer <FQDN|IPADDR>
[no] severity <<LEVEL> |
[active <LEVEL>] |
[inactive <LEVEL>]>
condition <high|low>
threshold <NUM | [rising <NUM>] |
rising 0
[falling <NUM>]>
falling 0
[no] interval <SECONDS>
3
[no] number <NUM>
3
[no] outbound <IFNAME>
Disabled
[no] action <INDEX>
1
show types
[no] action <INDEX>
[no] target <[log] [snmp] [led] >
log
[digout] [reboot] [custom]>
[no] custom <COMMAND>
Disabled
[no] summary-trap
Alarm Status
alarm
show
➞ 2015 Westermo Teleindustri AB
553