Festo Контроллеры двигателя SFC-LAC - Manual (Page 110)

5. Commissioning
5−6
Festo GDCP−SFC−LACI−DN−EN en 0812NH
5.1.3 Before switching on
When the SFC−LACI is switched on, the controller interface is
activated as standard [HMI = off ].
Caution
Unexpected movements of the drive due to incorrect
parameterising
· Make sure that there is no active ENABLE signal when
switching on the SFC−LACI on the controller interface.
· Parameterise the entire system completely before
activating the controller with ENABLE or [HMI = on].