Festo Контроллеры двигателя SFC-LAC - Manual (Page 218)

A. Technical appendix
A−4
Festo GDCP−SFC−LACI−DN−EN en 0812NH
Electrical data
Load voltage supply
Ĉ Nominal voltage
Ĉ Nominal current (max. continuous
motor current)
Ĉ Peak current
Power connection, pins A1, A2)
48 VDC (+5/−10 %) (Load power down:
Ţ 36 V)
10 A
20 A
Logic voltage supply
Ĉ Nominal voltage
Ĉ Nominal current Power connection, pins 1, 2
24 VDC ±10 %
3.8 A (when using the local digital outputs, see section 3.2)
Protection against electric shock
(protection against direct and indirect
contact as per IEC/DIN EN 60204−1) By means of PELV power circuit
(Protected Extra−Low Voltage)
Parameterising interface specification RS232, 38400 Baud, see chapter 3.5
DeviceNet data
Version
Ĉ Physical layer
Ĉ Data link layer
As per ISO 11898 (corresponds to DS102)
As per CAN specification 2.0
DeviceNet specification As per IEC 62026 and EN 50325
Predefined connection set: Group 2 slave only"
Manufacturer ID Festo Corporation" 26 (0x1A)
DeviceNet device type Communication adapter" (0x0C / 12)
Product code 9011
Address range (MAC ID) 0 ... 63
Baud rate 125, 250, 500 kBaud
Interface
Ĉ Plug connector
Ĉ Electrical isolation
Ĉ Integrated bus terminal
Sub−D 9−pin, plug
Yes
No
Cable type Depends on length of cable and field bus baud rate,
seeĂcontroller manual