Festo Контроллеры двигателя SFC-LAC - Manual (Page 148)

5. Commissioning
5−44
Festo GDCP−SFC−LACI−DN−EN en 0812NH
1.Create readiness to operate ć Record select
Step/
D
i ti
Control bytes Status bytes
Description
Byte B7 B6 B5 B4 B3 B2 B1 B0 Byte B7 B6 B5 B4 B3 B2 B1 B0
1.1 Basic status Byte 1 OPM2 OPM1 LOCK ć RESET BRAKE STOP ENABL Byte 1 OPM2 OPM1 HMI 24VL FAULT WARN OPEN ENABL 1.1 Basic status
(Device control
CCON 0 0 0 0 0 0 0 0 SCON 0 0 0 1 0 0 0 0
(Device control
HMI = off )
Byte 2 ć CLEAR TEACH JOGN JOGP HOM START HALT Byte 2 REF STILL DEV MOV TEACH MC ACK HALT HMI = off )
CPOS x 0 0 0 0 0 0 0 SPOS 0 0 0 0 0 1 0 0
1.2 Disable device Byte 1 OPM2 OPM1 LOCK ć RESET BRAKE STOP ENABL Byte 1 OPM2 OPM1 HMI 24VL FAULT WARN OPEN ENABL 1.2 Disable device
control by FCT/HMI
(optional)
CCON x x 1 x x 0 x x SCON x x 0 x x x x x
(optional)
Byte 2 ć CLEAR TEACH JOGN JOGP HOM START HALT Byte 2 REF STILL DEV MOV TEACH MC ACK HALT
CPOS x x x x x x x x SPOS x x x x x x x x
1.3 Enable drive, Byte 1 OPM2 OPM1 LOCK ć RESET BRAKE STOP ENABL Byte 1 OPM2 OPM1 HMI 24VL FAULT WARN OPEN ENABL 1.3 Enable drive,
enable operation
CCON 0 0 x x 0 0 1 1 SCON 0 0 0 1 0 0 1 1
(Record selection) Byte 2 ć CLEAR TEACH JOGN JOGP HOM START HALT Byte 2 REF STILL DEV MOV TEACH MC ACK HALT (Record selection)
CPOS x 0 0 0 0 0 0 1 SPOS 0 0 0 0 0 1 0 1
0: 0−signal
1: 1−signal
x: not relevant (optional)
F: Edge positive
Tab. 5/4: Control and status bytes a Establish readiness ć set selection"
Description of 1. Create readiness to operate
1.1 Basic status of the drive when the supply voltage has
been switched on
} Step 1.2 or 1.3
1.2 Optionally: Disable device control via FCT/HMI using
CCON.B5 = 1 (LOCK)
} Step 1.3
1.3 Enable drive in Record Select mode
} Homing: Example 4, Tab. 5/7
If there are faults after switching on or after setting
CCON.B0Ă(ENABLE):
} Fault handling: see example 3, Tab. 5/6 and
section 6.3 Error messages"