Festo Контроллеры двигателя SFC-LAC - Manual (Page 341)

C. CI interface
C−5
Festo GDCP−SFC−LACI−DN−EN en 0812NH
C.1.3 Access via a terminal program
For data transmission you will require a commercially−availĆ
able terminal program or the integrated CI terminal of the
SFC−LAC PlugIn in the Festo Configuration Tool.
1. Connect the SFC−LACI to your PC (see section 3.5).
2. Configure your PC’s COM interface:
Settings of the COM interface
Transmission speed (baud rate) 38400 Baud
Data format Asynchronous character frame:
Ĉ 1 start bit
Ĉ 8 data bits
Ĉ No parity bit
Ĉ 1 stop bit
Tab. C/1: Settings of the COM interface
3. You can use the following command to initialise data
transmission and determine the SFC−LACI’s response
readiness:
Command Reply
1 <CR> 11 <CR>