Festo Контроллеры двигателя SFC-LAC - Manual (Page 204)

6. Diagnosis and fault display
6−8
Festo GDCP−SFC−LACI−DN−EN en 0812NH
Warnings Warnings have no influence on the behaviour of the drive.
The cause of the warning should be eliminated in order that it
does not lead to a malfunction.
If a warning occurs, the error LED will flash and the SCON.B2
WARN output will be set (FHPP status bits, see section 5.5.2).
Warning Cause PNU 215 Fault no. *)
INDEX PULSE
WARNING During homing: The homing switch signal lies too
close to the index pulse. In some cases Ăthis can mean
that no reproducible reference position can be
determined.
· See section 6.6
0x0001 84
WARNING
MOTOR COLD Temperature of the linear motor <Ă−10 °C
Increase the ambient temperature as appropriate. 0x0002 108
WARNING
MOTOR HOT Temperature of the linear motor 70 ... 75 °C
Check for possible overloading of the drive; check the
mechanical system, e.g. for sluggishness; reduce
ambient temperature. 0x0004 109
WARNING
SFC−LACI COLD Temperature <āāĂ −10 °C 0x0008 74
WARNING
SFC−LACI HOT Temperature 80 ... 85 °C 0x0010 75
STANDSTILL
WARNING The axis has moved outside the standstill tolerance
window 0x0020 36
ILLEGAL
RECORD
WARNING Impermissible record number 0x0040 3
*) Fault number in the diagnostic memory, see section 6.4.2.