2 h-rail mounting, H−rail mounting – Festo Контроллеры двигателя SFC-LAC User Manual
Page 54
![background image](/manuals/464472/54/background.png)
2. Fitting
2−6
Festo GDCP−SFC−LACI−DN−EN en 0812NH
2.3.2
H−rail mounting
Procedure:
1. Make sure that the mounting surface can support the
weight (approx. 1500 g) of the SFC−LACI.
2. Install an H−rail (mounting rail EN 50022 ć 35āxā7.5 or
better still 35āxā15).
3. For rail 35āxā7.5: the max. distance is 3.3 mm between the
housing web and the H−rail.
·
If possible, use a part of the H−rail where there are no
mounting screws.
·
If screws are necessary below the SFC−LACI: use
e.g. an M6 screw as per ISO−7380ULF.
4. Hang the SFC−LACI on the H−rail as follows:
·
first from below, pressing against the tension springs,
then
·
press up against the H−rail so that the SFC−LACI clicks
into place.
1
H−rail
2
Tension springs
3
Distance between
housing web and
H−rail: 3.3 mm
(railĂ35āxā7.5)
1
2
3
Fig. 2/3: H−rail mounting