Festo Контроллеры двигателя SFC-LAC - Manual (Page 299)

B. Parametrizing via field bus
B−79
Festo GDCP−SFC−LACI−DN−EN en 0812NH
B.4.8 Project data
General project data
Project Zero Point
PNU 500 ć int32 rw
Description Offset of axis zero point to project zero point.
Reference point for target positions with absolute positioning
(compare PNU 401 and 404).
CI 21F4h 00h int32 rw
DeviceNet C: 105 Aā: 1 I: 1 int32 rw
Software End Positions
PNU 501 1 ... 2 int32 rw
Description Software end positions in increments
Plausibility rule: Min. limit
Ţ Max. limit
Factory settings: see section 5.2.6
Lower Limit 501 1
Lower software end position: Offset from axis zero point
Upper Limit 501 2
Upper software end position: Offset from axis zero point
CI 607Bh 01h ... 02h int32 rw
DeviceNet C: 105 Aā: 2 ... 3 I: 1 int32 rw