Festo Контроллеры двигателя SFC-LAC - Manual (Page 48)

1. System summary
1−26
Festo GDCP−SFC−LACI−DN−EN en 0812NH
1.3 Commissioning options
You can parameterise and commission the SFC−LACI as
follows:
ć with the Festo Configuration Tool (FCT)
} section 5.3
ć at the control panel (HMI, nur Typ SFC−LACI−...−H2)
} chapters 4 and 5
ć via DeviceNet (DN) } section 5.4.1
Functions HMI FCT DN
Parameterisation Ĉ Choice: Drive and associated parameters
Ĉ Uploadingāā/ādownloading of configuration data
Ĉ Saving different configurations in projects
Ĉ Creating a position set table
Ĉ Configuration of a chained record
Ĉ Parameterising force mode
Ĉ Parameterising jog mode x
ć
ć
x
ć
ć
ć x
x
x
x
x
x
x x
x
x
x
x
x
x
Commissioning Ĉ Homing run (limited selection with HMI)
Ĉ Teaching of positions
Ĉ Testing position sets
Ĉ Testing set chaining
Ĉ Testing force mode
Ĉ Testing jog mode
Ĉ Testing continuous setpoint specification (x)
x
x
x
ć
ć
ć
x
x
x
x
x
x
ć x
x
x
x
x
x
x
Diagnostics / Service Ĉ Reading and displaying diagnostic data
Ĉ Oscilloscope function (trace): Graphic presentation of
positioning procedures
x
ć x
x x
ć
Parameterisation can also be done via the parameterisation
interface with CI commands (
} section B.2).
Only experienced users may operate the module by means of
CI commands.